Hi guys, Can anybody help me out here? I bought a second user AKD 6M FM transceiver but never got a handbook with it and it looks like the. AKD 6M FM TRANSCEIVER | eBay! Details about AKD 6M FM TRANSCEIVER. See original listing. AKD 6M FM TRANSCEIVER. Type: Amateur VHF transceiver. Frequency Range: MHz ( channels/10 KHz spacing). Mode: FM. RF Power output: Hi: 25 W Lo: 5 W. Sensitivity: N/A.
|Genre:||Health and Food|
|Published (Last):||5 February 2016|
|PDF File Size:||15.7 Mb|
|ePub File Size:||12.94 Mb|
|Price:||Free* [*Free Regsitration Required]|
Most drive parameters are supported over Modbus TCP see Modbus Parameter Table with the exception of commands which output character strings.
For information about the Modbus protocol, please see: Connect the drive and a device such as an HMI to a working Ethernet network. For ease of testing and configuration, connect a PC running WorkBench to the same network.
After booting, the drive will flash its Ethernet IP address on the front display. The drive can be accessed at this address for Modbus on port WorkBench uses the same address, but a different port number.
Once the devices are connected, the connected device can open a connection to the AKD using these settings:. All parameters with an internal data width of bit and lower are mapped to Modbus as bit 2 register values.
AKD 6M FM TRANSCEIVER | eBay
The contents of both registers must be read or written in the same message, by setting the Starting Address to the lowest index of the parameter and the Quantity of Registers to two. All parameters with an 601 data width of bit are mapped to Modbus as bit 4 register values.
The contents of all four registers must be read or written in the same message by setting the Starting Address to the lowest index of the parameter and the Quantity of Registers to four.
Parameters are scaled as in the Terminal window of WorkBench, but note that floating point values are scaled by an additional factor of 1, to retain precision.
AKD 6001 Programing software
To allow only bit and bit access, the quantity of registers is limited to two registers for bit variables and four registers for bit variables. Other quantities return an exception response. See Exception Response Codes.
Following is an example of reading the position loop feedback PL. FB at index 0xCwith an actual value of 0x1 2A05 F Following is an example of setting the mode of digital input 1 DIN1.
MODE at index qkd to a value of 3. Illegal Block Size must be two registers for bit and four registers for bit parameters. Stay Connected with Kollmorgen. Two bit values or four bit values. Unknown Parameter bad address. Error Processing Command such as “Data value is greater than maximum”.
Byte Count field is invalid in request.