ASTM E1032 PDF

This test method is under the jurisdiction of ASTM Committee E07 on This standard is issued under the fixed designation E; the number immediately. Buy ASTM E TEST METHOD FOR RADIOGRAPHIC EXAMINATION OF WELDMENTS from SAI Global. ASTM E, Standard Test Method for Radiographic Examination of Weldments. has been cited by the following article: TITLE: Acoustic Emission Studies.

Author: Mikakora Zoloran
Country: Dominican Republic
Language: English (Spanish)
Genre: Travel
Published (Last): 22 January 2013
Pages: 456
PDF File Size: 4.23 Mb
ePub File Size: 2.69 Mb
ISBN: 741-4-76350-676-2
Downloads: 85875
Price: Free* [*Free Regsitration Required]
Uploader: Togrel

The radiographic techniques stated herein provide adequate assurance for defect detectability; however, it is recognized that, for special applications, specific techniques using more stringent requirements may be required to provide additional detection capability.

E Practice for Calibration of Transmission Densitometers.

ASTM E – 01 Standard Test Method for Radiographic Examination of Weldments

The apparatus shall comprise of a radiation source which may be X-ray or gamma-ray source; film holders and cassettes; intensifying screens such as lead-foil, fluorescent, fluorometallic, or other metallic screens; filters which shall be used whenever the contrast reductions caused by low energy, scattered radiation, or the extent of undercut edge burn-off occurring on production radiographs are of significant magnitude to cause difficulty in meeting the quality level or radiographic coverage requirements stipulated by the job order or contract; masking to improve radiographic quality; IQI’s or penetrameters; shims, separate blocks, or like sections to facilitate IQI positioning; radiographic location and identification markers; and radiographic density measurement device.

  GOULD EL PULGAR DEL PANDA PDF

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. For more specific safety precautionary information, see Section 7. Link to Active This link will always route to the current Active version of the standard.

ASTM E1032 – 12

This test method provides a uniform procedure for radiographic examination of weldments using industrial radiographic film. Link to Active This link will always route to the current Active version of the standard. Requirements expressed e10032 this method are intended to control the quality of the radiographic images and are not intended for controlling acceptability or quality of welds.

Procedures for surface preparation, radiation application and protection, IQI selection and placement, shim utilization, radiograph identification, and single-wall or double-wall radiographic techniques are addressed. This abstract is a brief summary of the referenced e132. In these cases, the use of alternative radiographic techniques shall atsm as agreed upon between purchaser and supplier also see Section 4.

Requirements expressed in this method are intended to control the quality of the radiographic images and are not intended for controlling acceptability or quality of welds.

  FERRUGEM ASIATICA PDF

For more specific safety precautionary information, see Section 7. Work Item s – proposed revisions of this standard. E Practice for Calibration of Transmission Densitometers. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

Active view current version of standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. The test method shall meet the radiographic coverage, radiographic film quality, radiographic quality level, acceptance level, and radiographic density limitations.

The use of specific radiographic techniques shall be agreed upon between purchaser and supplier. Work Item s – proposed revisions of this standard. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Historical Version s – view previous versions of standard. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.